Home  /  News

Anti-static Floor Construction Steps

May. 20, 2019

Calcium Sulphate Anti-Static Floor Factory to explain the construction steps of the anti-static floor.

1. Carefully check the flatness of the ground and the verticality of the wall. If any major defects are found or need to be partially modified, it should be submitted to the relevant department;

2. Pull the horizontal line and use the ink line to hit the wall surface to ensure that the floor after laying is in the same level, measure the length, width and selection of the reference position in the room, and pop the network grid of the mounting support on the ground. To ensure that the laying is neat and beautiful while minimizing the cutting of the Raised Floor Perforated Panel;

3. Adjust the support to be installed to the same required height and place the support at the intersection of the ground grid lines;

4. Fix the truss beam to the support with the mounting screws, and correct the truss beams one by one with the horizontal ruler and the right angle ruler so that they are both in the same plane and perpendicular to each other;

Calcium Sulphate Raised Access Floor System

5. Place the raised floor on the assembled truss beam with a suction plate;

6. If the remaining size near the wall is smaller than the length of the raised floor, you can use the method of cutting the floor to make up;

7. When laying the Calcium Sulphate Raised Access Floor System, the level of the blistering level is leveled by block. The height of the raised floor is adjusted by the adjustable support. During the laying process, it should be handled gently to prevent scratching the floor and damaging the edge strips. It should be cleaned while laying to avoid leaving debris and dust under the floor;

8. When installing heavy equipment in the equipment room, install support under the floor of the equipment base to prevent deformation of the floor;

9. When the HPL decorative board needs to be cut or opened, the φ6~φ8 cracking hole should be made at the concave corner of the opening to prevent the cracked floor decoration surface after processing.