Home  /  News

Anti-static Floor Selection Method

Jul. 27, 2019

Calcium Sulphate Anti-Static Floor Factory to share with you the choice of anti-static floor.

1. Firstly, the total area (or the number of blocks) of anti-static floor required for the construction of the computer room and the number of various accessories (standard bracket ratio 1:3.5, standard beam ratio 1:5.2) must be accurately calculated. Quantity, so as not to cause waste or shortage.

2. Fully understand the variety and quality of anti-static flooring produced by manufacturers, as well as various technical performance indicators.

The technical performance of the Calcium Sulphate Raised Access Floor mainly refers to its mechanical and electrical properties. Mechanical properties mainly consider its bearing capacity and wear resistance.

3. The load of the anti-static floor should be determined based on the weight of the heaviest equipment in all equipment in the equipment room. This can prevent some equipment from being overweight and causing permanent deformation or damage to the floor.

Wood Core Raised Floor with Modular Pedestal System

4. The anti-static floor is subject to small changes due to the influence of external environmental conditions. That is, the external environment temperature is too high or too low, and the expansion is obvious. That is, when the temperature in the machine room is slightly higher, the Wood Core Raised Floor with Modular Pedestal System is expanded and cannot be removed and replaced; when the temperature is low, the antistatic floor shrinks. Produces a sense of looseness. The amount of shrinkage of the anti-static floor affected by the environment should be less than 0.5mm, and the deflection of the board surface should be less than 0.25mm.

5. The surface of the anti-static floor should be non-reflective, non-slip, corrosion-resistant, dust-free, dust-free, and easy to clean.