Home  /  News

How to Identify Inferior Anti-static Flooring?

Jul. 01, 2019

Nowadays, there are many anti-static floor manufacturers on the market, but the quality of the floor is uneven. Some merchants only ask for the profit without guaranteeing the quality, which leads to a large number of inferior and unqualified anti-static floors in the market. These inferior products not only harm the interests of consumers. It has hit the confidence of consumers to buy products, and it has also had a very bad impact on the industry. Here, Raised Floor Steel Perforated Panel Supplier teaches you how to identify inferior anti-static flooring.

One: First of all, in the thickness of the anti-static floor, the inferior anti-static floor will cut corners on the standard thickness. For example, the thickness of the original steel plate is 0.7/0.8 or 1.0mm, and the final cut is 0.3, 0.4mm, which greatly reduces the thickness. This thickness reaches an undue strength and easily causes cracking of the floor.

Two: After reading the anti-static floor itself, now speaking about the floor accessories - the beam, the beam wall is also very important, the bad business to reduce the thickness of the beam wall from 0.8mm / 1.0mm to 0.3mm, 0.4mm, Because the beam is too soft, the four sides of the floor are tilted up, and the middle is recessed, which seriously causes the floor to collapse and break.


Wood Core Raised Floor with Modular Pedestal System


Third: the thickness of the bracket steel plate, the pipe wall to the back are reduced to varying degrees, and the support can not be sustained, there will be noise.

Four: The thickness of the Aluminum Access Floor Pedestal veneer is cut off. The anti-static floor veneers used in the South and the North are different. The south must be 0.8mm/1.0mm/1.2mm/1.5mm, while the north must be 1.2mm or more. Inferior floor coverings do not reach this standard thickness, which directly leads to a significant reduction in the service life of the floor.

Five: Wood Core Raised Floor with Modular Pedestal System, not only look at the thickness but also one can not be ignored is whether the anti-static system resistance of the veneer reaches the standard 1*106~1*109Ω. If it is not reached, it will cause the floor to be non-static, so the surface is purchased with the anti-static floor. In fact, it is an overhead floor, not anti-static!