Home  /  News

Laying Steps for Anti-Static Perforated Floor

Aug. 14, 2019

As a Raised Floor Steel Perforated Panel Supplier, let's share with you the steps of laying the Anti-Static Perforated Floor.

1. Carefully check the flatness of the ground and the verticality of the wall. If any major defects are found or need to be partially modified, it should be submitted to the relevant department;

2. Pull the horizontal line and use the ink line to hit the wall surface to ensure that the floor after laying is in the same level, measure the length, width and selection of the reference position in the room, and pop the network grid of the mounting support on the ground. To ensure that the laying is neat and beautiful while minimizing the cutting of the floor;

3. Adjust the support to be installed to the same required height and place the support at the intersection of the ground grid lines;

4. Fix the truss beam to the support with the mounting screws, and correct the truss beams one by one with the horizontal ruler and the right angle ruler so that they are both in the same plane and perpendicular to each other;

Anti-Static Perforated Floor

Anti-Static Perforated Floor

5. Place the Anti-Static Perforated Floor on the assembled truss with a suction plate;

6. If the remaining size near the wall is smaller than the length of the raised floor, you can use the method of cutting the floor to make up;

7. When laying the floor, the level of the blistering level is leveled by block. The height of the raised floor is adjusted by the adjustable support. During the laying process, it should be handled gently to prevent scratching the floor and damaging the edge strips. To avoid leaving debris and dust under the floor;

8. When installing heavy equipment in the equipment room, install support under the floor of the equipment base to prevent deformation of the floor;

Our company specializes in High Performance Anti Static Raised Floor. If you are interested in our products, please feel free to contact us.